Pellet Stoves - Chimney Installations

England's Stove Works recommends professional installation of our hearth products. **Always follow local codes. Refer to your stove and vent pipe owner's manuals, and contact the manufacturer with any questions.

NOTE: England's Stove Works strongly recommends installation of smoke and carbon monoxide detectors when installing ANY  type of stove.

See your Owner's Manual (you may download the latest version for no charge from the Support section of our website) for information on chimney installation. Consult a professional installer and/or call (800) 245-6489 or email service@englanderstoves.com for more information.

Outside Air (Outside Combustion Air Intake)

Outside air is mandatory for this unit to operate properly. This unit has been designed and tested with this connection, because so many homes are airtight and there is not adequate combustion air available inside the dwelling.
The air intake pipe is located on the bottom  of the burn pot (from the rear) and measures 1 1/2" inside diameter (I.D.). The connection can be made with a metal 1 7/8" I.D. coupler and pipe (see your stove's manual), and should exit through the wall. Be sure to secure the pipe to the unit with a clamp or aluminum tape. The outside end of the pipe should be covered (screened) to prevent foreign matter from entering the system.
Our Outside Air Kit (Part Number PU-OAK) can be used. If the unit is located below ground level, you will need to run the pipe up and then outside the dwelling.

NOTE: If the total run of the connection exceeds 6', if more than 2 elbows are used, or if a basement installation, use 3" metal pipe (and coupler) instead. If an older unit, measure the opening to determine what size pipe to use or couple to.

(Pre-manufactured Chimney Illustration)

High Altitude Installation

If the unit is being installed at an altitude of 4,000 ft. above sea level or higher, the following amendments to the chosen installation should be made:

  1. The pellet vent pipe size should be increased to 4". If connecting to an existing chimney use 4" pellet vent pipe.
  2. The outside air intake should be increased to 3".